| 2016 | 2종 전자근관장측정기를 이용한 근관장 측정 시 '0.5 MARK'와 'APEX MARK'에서의 정확도 및 일관성에 관한 in vivo 연구
| Thesis |
| 2021 | 3D printing을 이용한 투명 교정 장치의 전치부 초기 단계 배열에 대한 목표 달성 평가
| Thesis |
| 2021 | 3차원 CBCT를 이용한 골격성 안면 대칭 평가에서 프랑크포르트 평면의 변화가 미치는 영향
| Thesis |
| 2022 | 3차원 스캔 모형 기반으로 제작된 설측 고정식 유지장치의 정확도 및 안정성
| Thesis |
| 2009 | A comparative clinical study on oxidized titanium implants and sandblasted large-grit acid etched implants in soft bone
| Thesis |
| 2014 | A comparative study of gap volume after retro-filling using 4 different filling materials : evaluation by micro-computed tomography
| Thesis |
| 2015 | A comparison of failure load for zirconia-ceremics restorations with different zirconia/veneer thickness and cooling rate
| Thesis |
| 2009 | A comparison of the bone-like apatite formation potency between Hydroxyapatite and β-Tricalcium phosphate in Glass ionomer dental luting cement
| Thesis |
| 2004 | A comparison of the fit of cast and machine-milled titanium copings
| Thesis |
| 2008 | A critical role of Wnt5a during murine tooth development
| Thesis |
| 2016 | A proposal of 3-dimensional assessment of face with CBCT images : a pilot study of facial analysis with 'anterior facial pyramid'
| Thesis |
| 2021 | A retrospective study for prediction of factors affecting survival of primary molars following pulpotomy with mineral trioxide aggregate
| Thesis |
| 2010 | A short-term clinical study of marginal bone level change around Osstem GSIII implants
| Thesis |
| 2012 | A short-term survival rate of astra tech implants : a retrospective analysis
| Thesis |
| 2002 | A study on fissure penetration and microleakage of sealants after preparations of occlusal pits and fissures
| Thesis |
| 2014 | A systematic review of the accuracy and the assessment methods of implant impression techniques
| Thesis |
| 2023 | A Two-Center Randomized Controlled Trial of Two Calcium Silicate-based Materials for Pulpotomy of the Mature Permanent Teeth
| Thesis |
| 2012 | Accuracy of a cast fabricated with the i-Tero digital impression system
| Thesis |
| 2011 | Accuracy of a lingual indirect bonding system using a 3D virtual program
| Thesis |
| 2016 | Accuracy of indirect bracket bonding via virtual setup and 3D printing
| Thesis |
