Change in the Shrinkage Forces of Composite Resins According to Controlled Deflection

Abstract

The aim of this study was to investigate how the polymerization shrinkage forces of composite resins change with change in deflection. Five composites, SDR (Dentsply Caulk, Milford, DE, USA), EcuSphere-Shape (DMG, Hamburg, Germany), Tetric N-Ceram Bulk Fill (Ivoclar Vivadent, Schaan, Liechtenstein), CLEARFIL AP-X (Kuraray Noritake Dental Inc., Sakazu, Kurashiki, Okayama, Japan), and Filtek Z350 XT (3M Dental Products, St Paul, MN, USA), were tested in this experiment. The polymerization shrinkage forces of the composites were measured using a custom-made tooth-deflection-mimicking device and software (R&B Inc, Daejon, Korea). In all measurements, six modes were tested: maximum-deflection, zero-deflection, and four deflection-controlled modes. For each deflection mode, the shrinkage forces were recorded continuously every 0.1 second for 180 seconds. Polymerization shrinkage and flexural modulus were also measured. Eight specimens of each material were allocated for each test. For each material, six groups of shrinkage force values were compared using one-way ANOVA and Tukey post hoc tests at a 95% confidence level. The polymerization shrinkage force of each material in each of the six deflection modes was analyzed with 95% confidence using one-way ANOVA and Tukey post hoc tests. The relationship between the force measured in the six deflection modes and the linear polymerization shrinkage and flexural modulus was analysed with 95% confidence using Pearson correlation analysis. For each material, the following held true: the shrinkage force was highest in zero-deflection mode, the force decreased as deflection increased, and the smallest force appeared in maximum-deflection mode (p<0.05). There was a high negative correlation between allowable deflection and shrinkage force in all materials.