YUHASpace Repository
YUHSpace
BROWSE
0
6
Cited 0 times in 
Cited 0 times in 
Pressure analysis during impression-making procedure with various tray designs using a digital occlusion analyzer: An in vitro study
- Authors
- Minji Sun ; Jaeyoung Kim ; Seojune Choi ; Hong Seok Moon
- Citation
- JOURNAL OF PROSTHODONTICS-IMPLANT ESTHETIC AND RECONSTRUCTIVE DENTISTRY, : epub., 2025-06
- ISSN
- 1059-941X
- Issue Date
- 2025-06
- MeSH
- complete denture ; digital occlusal analyzer ; impression making ; pressure ; relief ; vent hole
- Keywords
- Purpose: The purpose of this study was to evaluate the pressures generated under various relief conditions during impression-making using the digital occlusal analyzer. Materials and methods: A customized device and impression trays were designed to measure pressure during impression-making. The left half of the tray consistently had a 0.5 mm relief without vent holes as the control group, while the right half featured varying relief and vent hole designs, resulting in six different trays. Two impression materials (Materials A and B) were loaded onto each tray, and relative pressure was measured using the digital occlusal analyzer (T-Scan Novus, Tekscan, Inc.). The pressure-reduction ratio of each experimental side was calculated. Two-way analysis of variance (ANOVA) was used to evaluate the effect of relief conditions and impression materials on the pressure-reduction ratio, followed by post hoc multiple comparisons with Bonferroni adjustment (α = 0.05). Results: The pressure-reduction ratio was significantly influenced by both impression material and relief amount (p < 0.001), with a significant interaction between the two factors (p < 0.001). In Material A, pressure reduction was significantly greater at 3 mm compared to 1 and 2 mm, whereas in Material B, pressure reduction increased progressively with greater relief amount. Regarding vent hole design, both impression material and vent hole configuration significantly affected pressure reduction (p < 0.001), with no significant interaction (p = 0.767). Designs with smaller but more widely spread vent holes demonstrated significantly greater pressure reductions, with significant differences observed only between the single-hole design and the two- or five-hole designs. Conclusions: Pressure reduction during impression making was influenced by both the viscosity of the material and the pressure-relief tray design. Forming vent holes yielded more consistent and effective results than adjusting the tray relief amount, highlighting the importance of a comprehensive approach that integrates both impression material selection and the application of various pressure-relief tray designs.
- Abstract
- 10.1111/jopr.14087
- DOI
- 40550779
- Appears in Collections:
- 2. College of Dentistry (치과대학) > Dept. of Prosthodontics (보철과학교실) > 1. Journal Papers
https://orcid.org/0000-0001-8118-8145- 사서에게 알리기
-
Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.
-
- License
DSpace Software Copyright © 2002-2017 Duraspace
Yonsei University Medical Library All right Reserves. / TEL:02-2228-2915 /
YUHSpace는 국립중앙도서관 OAK 보급사업으로 구축되었습니다.